|
Tools required:
- A Dremel clone and a *lot* of reinforced cutting disks
- A jig saw
- Some (needle) files
- Some hot melt glue
- Loads of masking tape
Date: 14.04.2005
Views: 253
|
Parts required:
- 2U standard rack mounting case from Maplin Electronics - part number XM68Y
- 21cm flat cable from Farnell - part number 3295102
- A free Saturday and Sunday to complete it in
Date: 14.04.2005
Views: 188
|
And then when you mix all these things together you could be left with the following end result
Date: 14.04.2005
Views: 178
|
|
The back
Date: 14.04.2005
Views: 170
|
The extra socket on the right of the picture above is for hardwired IR control. A number of DDARs could be mounted in the same rack and controlled using zoned IR from Homevision
Date: 14.04.2005
Views: 153
|
The internals
Date: 14.04.2005
Views: 199
|
